ELEKTRON 400 VC

• MixAssist® system – easy way of accurate mixing water with cleaning agent
• Two (optional three) tank system with two (optional three) separate circuit functions
• Vertical rotor system with CSR® (Cepter Spray Rotors)
• Fully automatic process: cleaning – rinsing - drying
• 100% closed circuit process – no water/waste water connection required
• All functions and settings are controllable via 10,1'' touchscreen display
• 100% stainless steel design
• Made in Slovenia

• PCBs
• Screens
• Misprints
• Stencils
• PumpPrints

Cepter ELEKTRON 400 VC is a compactly designed cleaning system in a full stainless steel finish with integrated smart solutions to achieve high productivity and low operating costs. It is completely engineered and produced in Slovenia.

Process description:

Cepter ELEKTRON 400 VC is a fully automatic single chamber 2-step process cleaning system.

Cleaning/Rinsing process: cleaning and rinsing fluids are pumped from separate tanks to CSR® (Cepter Spray Rotors) with special nozzles. Rotor design ensures efficient cleaning of products. Fluid circulates in loop through filter system to remove contamination for rinsing process.

Drying process: thoroughly cleaned materials are then efficiently dried. This is achieved by a highly efficient combination of hot air ventilation system and high pressure compressor.

-            Single chamber
-            3 tanks / 4 pumps
-            Cartridge for deionized and demineralized water
-            Active Carbon filter
-            100% closed loop circuit
-            Conductivity measurement – pre-rinse circuit
-            Vertical CSR® (Cepter Spray Rotor)
-            10,1'' touchscreen display
-            Coarse filter inside process chamber
-            Sediment filter inside fluid tanks
-            Fine 10'' filter in each circuit
-            Cleaning fluid heater
-            Rinsing fluid heater
-            Final rinsing fluid heater
-            2 Air heaters
-            Electric safety door locker
-            Fluid leakage tray in stainless steel
-            Leakage warning system
-            Complete machine body in stainless steel

-            Compressed air drying system in combination with CSR® (Cepter Spray Rotors) with special nozzles
-            FDS® (Fluid Drain System)
-            Status light
-            Mechanical carrier frame

Technical data
Chamber dimensions	W 400 mm x D 1.000 mm x H 1.000 mm
Capacity	Screens, stencils, frames up to size D 980 mm x H 910 mm
Volume cleaning tank	65 l
Volume rinsing tank	50 l
Volume final rinsing tank	50 l
Exhaust connection	Ø 100 mm
Power supply	400 V AC, 25A / 3 Ph / 50 Hz
Power consumption	ca. 2,8 kW
Temperature range cleaning	adjustable up to 65°C
Temperature range rinsing	adjustable up to 65°C
Temperature range drying	adjustable up to 95°C
Filter system	3-stage: 1. coarse filter < 2 mm; 2. sediment filter inside fluid tanks; 3. fine filter 10'' (1 – 100 µm)
Conductivity range	0 – 300 µS/cm
Noise level	< 70 dB
Dimensions	W 980 mm x D 1.580 mm x H 1.900
Weight	480 kg